SAE J1061 Surface Discontinuities on General Application Bolts, Screws, and Studs

作者:标准资料网时间:2024-05-20 02:34:05 浏览:9235 来源:标准资料网

Product Code:SAE J1061
Title:Surface Discontinuities on General Application Bolts, Screws, and Studs
Issuing Committee:Fasteners Committee
Scope:This SAE Recommended Practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs in sizes through 24 mm or 1 in diameter inclusive with lengths to 150 mm or 6 in inclusive, having specified minimum tensile strengths of 900 MPa or 120 000 psi and greater, which are primarily intended for use in automotive assemblies.The basic recommended practice does not include inspection sampling requirements. It is intended that the purchaser shall specify, in the original inquiry and purchase order, the inspection sampling requirements which the producer must satisfy to demonstrate the acceptability of bolts and screws with respect to surface discontinuities.

下载地址: 点击此处下载

返回跳至顶部

上一篇: SAE J2716 SENT - Single Edge Nibble Transmission for Automotive Applications
下一篇: SAE J1729 Parking Brake Drawbar Pull Test Procedure--Truck and Bus